Using SSH Keys To Access HPG

Introduction

After a new account is created on HiPerGator (HPG) you, as the account's owner, can log in using your credentials (GatorLink username and password for UF users). Mis-typing the credentials several times will result in a security system block of the user's IP address and can be slow. For convenience and speed, it may be useful to set up a SSH key pair to use.

SSH key pair means there are two keys:

1. A private key is stored in the ~/.ssh/ directory on the computer you are connecting from
   1. The private key acts as the identity file (the key part of the lock/key mechanism).
   2. Use a good passphrase to protect the private key in case it is accessed by someone else
   3. Use an SSH agent to store it, so you only have to type the passphrase in once when starting the computer or the terminal application.
2. A public key gets copied to every system you want to connect to and can be described as a specification for the 'lock' part of the lock/key ssh mechanism to allow the receiving computer connections to your account from a system that uses the private key part of the pair as its identify file.

The private key is not used automatically, although most systems are configured to use ~/.ssh/id_rsa by default. See how to configure your ssh setup to use the correct private key as the IdentityFile below.

Windows

See the following document that describes how to Create SSH keys on Windows.

SSH Configuration

A convenient configuration for your ssh client on your local computer. The ControlPath and following lines setup persistent connections so that you do not need to redo the MFA verification with every connection. Replace you username in the User line.

Host hpg
    User albertgator
    HostName hpg.rc.ufl.edu
    Port 2222
    ControlPath ~/.ssh/cm-%r@%l-%h:%p
    ControlMaster auto
    ControlPersist 8h

In all commands below you can now use 'hpg' instead of USER@hpg.rc.ufl.edu

Create SSH Keys

Note: You can also use a text editor (vi, vscode, etc) in a terminal or a console session in Open OnDemand to edit ~/.ssh/authorized_keys file. On MacOS these steps can be done using either the built-in MacOS terminal application or iTerm2.

The default cipher for ssh keys is RSA. However, this no longer recommended as it is less secure. We recommend users to use a ED25519 cipher when generating new keys in HiPerGator.

• Generate a key

ssh-keygen -o -a 100 -t ed25519 -f ~/.ssh/id_ed25519 -C "Comment to make the key recognizable among many"

• Add the following configuration at the top of the ~/.ssh/config file

Host *
  AddKeysToAgent yes
  IdentityFile ~/.ssh/id_ed25519
  IgnoreUnknown UseKeychain
  UseKeychain yes

• Configure your account on HiPerGator to accept the key instead of the username/password. If you are already logged in you can manually edit the ~/.ssh/authorized_keys file and add the new public ssh key as a single new line or run the following command, if available, on the local computer you generated your key pair on:

(substitute your real username for 'USER')

ssh-copy-id -i ~/.ssh/id_ed25519 USER@hpg.rc.ufl.edu